THE INVENTOR'S KNEE BOARD ASSEMBLY INSTRUCTIONS


TOOLS NEEDED:
-Diagonal Cutting Pliers
-Superglue


# I. 




## II. D
Slide the clip into the notch on the Knee Board.
Add a drop of Superglue [location.]

### III. INSTALL THE METAL CLIPS ON TO THE BACK OF THE KNEE BOARD
* Place one metal clip onto the back of the Knee Board.
* Line up the hole of the clip to the hole in the Knee Board.
* Insert the half of the rivet (that has a stem) through the hole of the clip and the Knee Board.
* Take the rivet cap and slide it underneath the front side of the Knee Board.
* Snap the rivet cap on to the rivet stem.

SET THE RIVETS
* Flip the Knee Board Over.
* Place the curved disk of the anvil underneath the rivet, on the back side of the Knee Board.
* Place the [stem] of the rivet setter onto the cap of the rivet on the front side of the Knee Board.
* Gently? strike the end of the Rivet Setter with a rubber mallet.  Don't hit the Rivet Setter with too much force or too little force.  You should practice setting rivets before you get to this step.
* This is the most dangerous part of the process, as you do risk damaging the Knee Board during this process.

* Once the clips are riveted to the Knee Board, you're done!

FINAL ASSEMBLY
* Take your notebook and flip the cover over.
* Slide the notebook into the Knee Board.
* Take your Zebra F301 and push the clicker down, so that you can see the tip of the pen.
* Remove the small plastic ball on the tip of the pen.
* Use the pen to scribble onto a sheet of paper, until the ink begins to flow.
* Push the clicker down to retract the tip of the pen.
* Now, push the clicker part into the top of the pen holder.  Depress the clicker half way.
* Now, push the tip of the pen into the bottom of the pen holder until it clicks.

Congratulations!  You now have a working Inventor's Knee Board!